Correzelandy
Member
- Posts
- 14
- Location
- Oxford
Not sure on the correct terminology here but will give it a try. Just a bought a 110 2 door '07 - absolutely amazing but a little tired in places. One particular place is rust on the rear corners between the pick up bed and van sides. Between the two panels appears to be a flimsy bit of foam ( not sure if that is factory standard). In the corner, where the water leaks down from the roof it collects there and on the inside the rust on the top is pretty bad. Nothing that won't last for a couple of years before I get the whole thing resprayed and can replace them.
But, in the meantime, would like to stop if I can the water seeping through that point inside as I want to line the inside with ply.
See attached photo where you can see that it has been sprayed to cover the worse of the damage by the previous owner.
And ideas welcome...
But, in the meantime, would like to stop if I can the water seeping through that point inside as I want to line the inside with ply.
See attached photo where you can see that it has been sprayed to cover the worse of the damage by the previous owner.
And ideas welcome...
