Currently preparing for my next offroad expedition and as i am expecting "some" water, decided to replace the axle, gearbox and tc breathers. I see many people seem to replace the original fitting with an angle push fit type: what sort of fitting will i need? Mine is a manual (r380) with a 1.4 transfer case. And do i i use the same fitting for axles, transfer case and gearbox?
Disco 2 Wading kit
- Thread starter mad85
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Flossie
Well-Known Member
- Posts
- 11,053
- Location
- Shropshire
Standard fittings are fine but if you want to extend the nylon tube then measure that (probably 6mm od)
And get straight pushfit connectors and a roll of the nylon tube, compressor/pneumatic places stock it if you've one near by.
And get straight pushfit connectors and a roll of the nylon tube, compressor/pneumatic places stock it if you've one near by.
- Posts
- 9,105
- Location
- Roaming the UK on assignments
You can buy whole kits that come with everything you need.
https://www.ebay.co.uk/itm/DISCOVER...971142&hash=item3d0f49180c:g:jJgAAOSwBiBarTIL
