Tyre mount for rear bulkhead??

Is there anywhere you can get a plate to attach the spare tyre to the rear bulkhead (behind the drivers seats) in a 90 CSW?? Cant seem to find nything of the sort?!

Long bolts and a spreader plate ..

They used to fit em to series landies have a look on ebay.

guess i could just use/adapt a bonnet mount kit sumint like this Land Rover Defender 90/110 Spare Wheel Bonnet Mount Kit on eBay (end time 22-May-10 23:16:43 BST)

Personally id just buy the door spare wheel bracket (if you done allready have one) and as said, mount it to the centre bulkhead reinforcing it with a spreader plate - job done and it'll set you back quite a bit less than that bonnet mounted wheel mount.

Ollie

i have one i could send you a picture if you want !

defender 90 300tdi said:

guess i could just use/adapt a bonnet mount kit sumint like this Land Rover Defender 90/110 Spare Wheel Bonnet Mount Kit on eBay (end time 22-May-10 23:16:43 BST)

Click to expand...

For starters, that eBay bonnet kit is bloody expensive, considering that it's missing all of the important bonnet strengthening bits

This is what it should have -




The bonnet and rear door mounts won't fit on the bulkhead.

The bulkhead isn't high enough to mount either of these carriers with the spare wheel mounted onto their studs, the carrier would have to sit higher than the bulkhead for them to be able to work.

The proper, bulkhead mounted spare wheel stowage fittings are shown below -




.

I've got one you can have. Took it off last week. You can have it if you pay the postage.

iv got one in my 110 pick up, original...

Its a swinging bolt on a little plate, that goes through the wheel then through a small plate and then a wing nut.simple does the job and doesnt require butchering the bulk head to fit a bonnet mount bracket thing..