Two rubber hoses going from cabin to ECU.

duncanpage4 · Jan 10, 2014

Hi
I noticed a rubber seal was slightly pulled out of the 'L' shaped box in the engine bay.
I removed the lid to re-fit it but just wondered what it was for?

Nodge68 · Jan 10, 2014

The pipes take cool air from the bulkhead to cool the ECUs before passing the warmer air back to the bulkhead again.

Hippo · Jan 10, 2014

If you switch off the engine when it's hot and allow the engine heat to warm it's surroundings a bit, then switch the electrics on then off you may hear the little fan running for a bit to cool it, if the temp sensor ses it's above the limit.

duncanpage4 · Jan 11, 2014

Thanks for the replies.
I'll make sure it stays water tight now!

Two rubber hoses going from cabin to ECU.

duncanpage4

Active Member

Nodge68

Well-Known Member

Hippo

Lord Hippo

duncanpage4

Active Member

Similar threads