Transfer box output seal assembly

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

timbr00

Member
Posts
73
Location
wareham uk
my transfer box was leaking into handbrake drum, I believe the cause to be a groove in the flange.
hard to describe but the old flange was of one diameter along its length, the new one has a chunkier bit at the base of about 5mm depth. the old one had a mud seal that fitted over the gearbox casing, this one appears to fit inside it. I have tried taping it over the flange so it's flush as suggested on a forum but it is very tight and doesn't seem to want to go. which way up should it be fitted?

any suggestions? any reason that I can't just use the old mud Shield with this flange?

IMG_8729.jpeg
IMG_8728.jpeg
IMG_8727.jpg.jpeg
 
Mismatching mud Shield and flange?
Flange on the diff can also have the same problem and also the seal also depends on which mud shield you use.
 
Back
Top