Tirfor problem

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
greenlanebasher

greenlanebasher

Active Member
Posts
175
Location
Cambridgeshire
Hi - I have just bought an old T35 and some new cable. I have fed it into the machine and it pulls it with no problems at all. The problem is that i cant get the cable back out again. I have pushed it out as far as i can with the backwards lever and the two levers have gone together at the top (like they do when it is in nuetral) but i can not pull it out. Anybody got any ideas. I have tried running some oil down the cable but it is not making any difference.

Any help please!!:confused:
 
Is it proper tirfor wire rope/?? and the proper size for the winch?? It should be able to be pulled or pushed thru either way when the cams are in release position. Have you pushed the front flat bar across to lock it open??
 
Here yu go yu can see what's what from here

TIRFOR1.jpg
 
Pull the flat bar out as far as it will go then pull the clutch lever up as far back as yu can and push the flat bar back in to lock it open. Rope should be freed up then.
 
I have had a good go at it this afternoon and managed to solve the problem. you have to squeeze the backwards lever and the releace lever together then push it foward until it clicks into the little notch at the top. Slides as free as you like then:p
 
You must log in or register to reply here.

Similar threads

S
speedometer input shaft problem
Replies
1
Views
241
tottot
tottot
A
Series 3 Wiper Motor Removal
Replies
9
Views
602
tottot
tottot
Padda.116
L322 stuck in park and handbrake stuck! Coolant Tanks also?
Replies
3
Views
382
Blob
Blob
Keith_L
Portable Winch
Replies
0
Views
672
Keith_L
Keith_L
C
snapped speedo cable Disco 1
Replies
14
Views
1K
Curly Oak
C
Back
Top