Temperature
- Thread starter Martyn110
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Nick108
Member
- Posts
- 10
- Location
- Bushey Hertfordshire
Hi Martyn nobody reply to your post and that was quite a while ago but do you remember or did you find the problem? I just changed water temperature transmitter PRC 2505 on my 2.5 NA as old one stop working an now my gauge also sits in a gap between white and red after about 5-10 minutes driving. Before it would be normally just around middle. Any idea why is like that? Cheers Nick
- Posts
- 9,023
- Location
- North Lincs
It looks like Martyn has not been on since March 2018. I had a similar problem and it ended up being the bullet connector where the cable splits into two cores by the bulkhead. It had become a high resistance joint. For me, after I replaced it, the gauge worked fine.
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
Between the white and red was normal on my 2.5na
Nick108
Member
- Posts
- 10
- Location
- Bushey Hertfordshire
Thanks guys I'll check whirring as My Old Landy suggest. Everything worked fine than stopped i wiggled bit whire on old one cleaned it worked again for a day and stopped dead. I replaced it after few weeks but as I said jump up high. Do you think it my be different calibration on certain parts so sender and gauge are not compatible as it's new sender and old gauge. I guess all of them are calibrated on Celsius setting not Fahrenheit.
