Td4 fuel rail pressure problem

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Rowbear

Member
Posts
11
Location
Belfast
Hi guys, I need a little direction on this one. My 2006 td4 loses power, starts ok, runs fine until I push for power then it loses power. No fault lights, scanning shows reduced high fuel pressure, if I stop the engine and restart it will run ok until I push for power. I've changed the high pressure sensor and checked the wiring to the ECU with a meter, all checked ok. If the sensor or wiring are faulty, will it always bring on the fault light?
 
Have you changed the low pressure electronic pump inc filter ?

post in the correct section and youl get decent help
 
Hi guys, I need a little direction on this one. My 2006 td4 loses power, starts ok, runs fine until I push for power then it loses power. No fault lights, scanning shows reduced high fuel pressure, if I stop the engine and restart it will run ok until I push for power. I've changed the high pressure sensor and checked the wiring to the ECU with a meter, all checked ok. If the sensor or wiring are faulty, will it always bring on the fault light?
https://www.landyzone.co.uk/land-rover/do-not-post-questions-please-read-before-posting.271449/

Try asking over here :)

https://www.landyzone.co.uk/forum/land-rover-freelander.9/
 
Have you changed the low pressure electronic pump inc filter ?

post in the correct section and youl get decent help
I've changed the filter, the low pressure pump seems to hold pressure. It's what I'm going to monitor next? When it goes into this mode it drops into limp mode, the scanner has most inputs reading low and on most occasions no engine light.
That's for your info re correct section, I'll do that now. Ta
 
Back
Top