Synergy 2 Dash switch

mfp2gosling1 · Mar 3, 2013

So havng bought a Synergy 2 with a dash switch I'm not sure where the best place is to fit it so where about have you guys fitted yours?

Pictures would be good

rhodie · Mar 3, 2013

mines right hand side of steering wheel passed lead through bonnet release cable hole.
attached with velcro

mfp2gosling1 · Mar 13, 2013

I had a look at this today Rhodie, you must have either tiny hands or be double jointed, I struggled with it for a while then gave up for the day, might try again tomorrow if the weather holds.

Did you put ot through with the cable or down the side between the rubber and bulkhead?

rhodie · Mar 13, 2013

mfp2gosling1 said:
I had a look at this today Rhodie, you must have either tiny hands or be double jointed, I struggled with it for a while then gave up for the day, might try again tomorrow if the weather holds.

Did you put ot through with the cable or down the side between the rubber and bulkhead?

Just remove water tank to one side and use a wire coat hanger

Singvogel · Mar 13, 2013

I've got an auto - so used the redundant rubber bung hole for where the clutch pedal would be.

frontosa · Mar 13, 2013

fitted mine right hand side of steering wheel next to cruse control switch.
will rtake a pic tomorrow

Synergy 2 Dash switch

mfp2gosling1

New Member

rhodie

Active Member

mfp2gosling1

New Member

rhodie

Active Member

Singvogel

Well-Known Member

frontosa

Active Member

Similar threads