stuck shackle pin/axle paint advice

Griffdowg said:

go put the urn on Si

Click to expand...

Would do....if it was fitted....works though I tested it. Got to fit me van sides before install it though

The Mad Hat Man said:

If you have one of those hacksaws with a square bolt type fitting at each end, there are 16 different ways of fitting the blade, CharlesY.

Click to expand...

Granted!
Good thinking, and just once in a blue moon that angled-blade ability might be useful.

But most of us are trying to keep our cuts straight-ish.

CharlesY

Got the old bush out after a few hours fettling, had the new bush in the freezer for a few days. Got myself a section of M12 threaded bar and some big washers etc etc. wound it in all nice n smooth for a while, it got harder so I wacked on the breaker bar and wound on, got harder. Its 5mm out now but I keep stripping threads on the bar or crushing nuts through washers, bent the threaded bar to!

any suggestions? I don t have an air compressor or anything fancy like that. I did try a hammer for a bit, but looks like I may start damaging something.

really am at a loose end now.

G