SRS ECU Problem

Turnover · Apr 24, 2010

Hi,

The problem is that the SRS light has come on. This is after the dash was taken out for the blend motors. I've tried to connect to the ECU with Faultmate with no luck. It times out. The supply is there and the coms wire is ok that goes from the SRS ECU to the diagnostic connector.

Any ideas?

Cheers

Chris

fanatic · Apr 24, 2010

srs plug by dash clocks not plugged in?

Turnover · Apr 24, 2010

Would that cause no coms?

Datatek · Apr 24, 2010

the comms is irrelavant, according to RAVE, although up to 5 faults are stored in the SRS ECU, the SRS lights should go out on the next ignition cycle after the fault has been corrected. In my case the fault is due to the drivers side airbag. I am about to sort it after reading RAVE, I will let you know if the SRS light does in fact go out when I fix the fault.

the hooded claw · Apr 24, 2010

Datatek said:
the comms is irrelavant, according to RAVE, although up to 5 faults are stored in the SRS ECU, the SRS lights should go out on the next ignition cycle after the fault has been corrected. In my case the fault is due to the drivers side airbag. I am about to sort it after reading RAVE, I will let you know if the SRS light does in fact go out when I fix the fault.

It Won't Data, ........... SRS is a HARD FAULT it'll need to be "Testbooked" to remove

Datatek · Apr 24, 2010

You might be right but that ain't what it says in RAVE.

SRS ECU Problem

Turnover

New Member

fanatic

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

Turnover

New Member

Datatek

Well-Known Member

the hooded claw

Well-Known Member

Datatek

Well-Known Member

Similar threads