Sorting out lights.

Bought my self some original look rdx style led lights , wipac crystals and a boomslang loom

The led lights come with new style sealed connectors which i either have to chop off and fit bullets.

Given bullets like to corrode and give issues - was for ever cleaning them up and replacing them previously - would i be better advised to change the wiring connector ends to the sealed type and quite a few bullets are already missing?

The only reason i can think of for not doing it is that compared to a hand ful of bullets they will be pricy ?

Since im not keeping it stock/ original anyway im open to ideas of better suggestions than land rovers offerings ..... But no effin scotchblocks/choclate blocks

Waterproof connectors 99p each wether they are 1, 2, 3, 4 or 5 pin strangely



Waterproof connector | eBay

Hav used above connectors and still hav a box full very fiddly and crap plastic [emoji90][emoji90] I would use bulits and cover them with vasoline never had any probs my series stuff once connectors where filled with it [emoji41][emoji106]

Soldered bullets will last as long as the harness they are connected to, DIY crimped joints are always going to be suspect.

Hmm been looking for an excuse to pick up soldering ... Its one thing ive never done.