Slow 35mph Message

i have recently fitted a coil conversion kit to my da's 2000 p38 ,fitted the wee by pass loom for the eas ecu but the message still reads slow 35mph max,only trouble is that it is also showing srs fault.
my question is will the srs show up this warning as well as the eas?
,gonna try connecting jumpers to the ecu plug to see if the fault will clear soon

has anyone got a diagram of the plug with number posisitions they can post by any chance

thanks in advance for any help


willy

its on the i button on the steering wheel colum and turn speed limit to off?i think

it might be the button with the bell on it?

roytheblade said:

it might be the button with the bell on it?

Click to expand...

That's the speed limit bell not the "slow 35mph" eas fault warning.

See Range Rover Air Suspension repair, advice and troubleshooting by Rover Renovations.

This is the EAS plug you need to jumper with the pin layout... (make sure the EAS ECU is left DISCONNECTED)



As for the SRS fault, it's a 2000 and you have been fiddling around under the seats, my guess is you have knocked one of the yellow wires that goes into the bottom of the seats, the side airbag wires. With ignition OFF unplug either side and then plug it back =in and see if the fault clears.

Lastly, why on earth was this spring converted??

-Wills

P.S. IF you are going to leave it spring converted please send me all the old EAS bits