Shed clearout - V8 going spare

I've got an old Rover P6 (1974 - Manual) V8 engine which is free to a good
home.

It was a good quiet runner when it came out about 5 years ago and gave good
oil pressure with no smoke and all the spark plugs ran clean. It was removed
when the P6 was scrapped and intended for a project Land Rover which never
happened.

It's free. It might need a total rebuild or it might be a runner with a
clean up.
It's almost complete, just a few bits were borrowed for other vehicles
(ignition leads, a bit of fuel pipe, maybe a flame trap.) but mechanically
all there.

Take it away or it will be scrapped. There's also a bare Perkins 4.203 block
which is probably only fit for scrapping but that's free too if you want.

I live very near Junction38 off the M6 (UK)
Un-mung my email address if you're interested or reply here.

"PDannyD" <[email protected]> wrote in
message news:[email protected]...
> I've got an old Rover P6 (1974 - Manual) V8 engine which is free to a good
> home.


If my unmunging has worked you should have mail.

If not, drat!

Lee D

Lee_D wrote:
> "PDannyD" <[email protected]> wrote in
> message news:[email protected]...
>> I've got an old Rover P6 (1974 - Manual) V8 engine which is free to
>> a good home.
>
>
> If my unmunging has worked you should have mail.

It did. You have a reply.
You're at the head of the queue of 1 so far.

Just been out to check it and I can turn the flywheel with a short
screwdriver levering off one of the metal dowels. One of the plastic caps of
a dash-pot has been broken off at some point but they shouldn't be too hard
to replace.