Series 3 stuff, new and used.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
crashbox

crashbox

Well-Known Member
Posts
12,347
Location
In the UK, thankfully.
I have decided to sell my Series Landy stuff , I have lots of parts, new and used. PM me if you need anything. Happy to post smaller stuff. Items are near Scottish/English Border on the East Coast. I also have a dismantled S3 (petrol) with a good restored chassis and a complete but knackered S3 (diesel). Also have a S2(a?) bulkhead in need of some restoration but has steering/dials etc fitted. Too good to scrap. Don't be frightened to ask for prices, you may get a pleasant surprise. :) I may add a list of parts later.
 
wondering if series doors would be any good on the 110. parts list could be interesting :)

got a mig for sale? :p
 
Right, here are some photos of some of the parts. I will make a more comprehensive list. I am kind of pushed for spare time at the mo' so please be patient, thanks.
 
Where are my photos? I will try again.
 

Attachments

  • Picture 010.jpg
    Picture 010.jpg
    333.8 KB · Views: 203
  • Picture 011.jpg
    Picture 011.jpg
    385.6 KB · Views: 198
  • Picture 012.jpg
    Picture 012.jpg
    312.7 KB · Views: 211
Looks like I was trying to upload too many at one time. I will add some more photos.
 

Attachments

  • Picture 013.jpg
    Picture 013.jpg
    281.5 KB · Views: 185
  • Picture 014.jpg
    Picture 014.jpg
    300.2 KB · Views: 176
  • Picture 015.jpg
    Picture 015.jpg
    322.4 KB · Views: 195
and some more...
 

Attachments

  • Picture 023.jpg
    Picture 023.jpg
    316.4 KB · Views: 128
  • Picture 022.jpg
    Picture 022.jpg
    295.5 KB · Views: 122
  • Picture 025.jpg
    Picture 025.jpg
    356.3 KB · Views: 146
  • Picture 024.jpg
    Picture 024.jpg
    326.4 KB · Views: 164
Here is a list of some items...1 good radiator, 1 nearly new radiator, 1 nearly new fuel tank,1 new water pump, 2 new rear bench seats plastic covers metal frames by Britpart, 1 front bumper with A bar, 2 bulkhead footwell repair panels (may sell with S2(a?) bulkhead), 2 under wing mud panels, brake pipe set (swb S3), 2 new brake hubs 11" diameter, good pass side door top, used but useable steering swivels, new rear step, used but good heater matrix in cover, plastic rad grilles, 2 front 2 rear new shockers, couple of sets of new springs swb, distributor, 3 new brake hoses, new lift pump, 2 new brake shoes stc3821, 3 new rubber gaitors for h/brake g/sticks, 6 new track rod end clamps incl nuts and bolts, 4 new check straps, 4 safety belts, new gaiter for prop, set new pedal rubbers, new clutch slave cylinder corresponds to 591231G dia 22.2mm, pair new swivel seals, set new wheel nuts, various spring shackles, long and short., crak? seals, used speedo cable, new track rod end with "normal" thread. I have lots more, did I mention a good S3 bulkhead, only needs the mounting brackets repaired.
 
I will add that I have a complete R reg S3 diesel Landrover in poor condition, the chassis is shot and the engine has a strange knock, possibly big ends but I am no expert. I have a complete S2a diesel engine and complete S3 petrol engine. Some gearboxes, axles, not tested. Also a truck cab and two rare cab to body panels, they fit at the rear of the cab and take up the gap. I have a loose rear tub, sides and roof. Numerous front wings and a seat base needing a bit repair to the sides.
 
Last edited:
You must log in or register to reply here.

Similar threads

D
Inheriting my fathers LHD Series 2A LWB
Replies
2
Views
629
Shedload
S
zooropa1993
Rainers Series 3 from Bremen
Replies
9
Views
1K
Flat frog
F
G
S3 dash - just what is available ?
Replies
6
Views
917
doriz
doriz
O
Disco 2 Where to source used parts?
Replies
1
Views
565
Landmark2
Landmark2
W
Land Rover series 3 Daihatsu diesel
Replies
8
Views
1K
tottot
tottot
Back
Top