series 3 rebuild

Hi All,
I'm rebuild a series 3 station wagon for my sister.
Its a swb. Its 1977 but it will hav 93 disco axles and drive train plus 200 tdi and all important power steering.
Any ideas about wiring looms and where can i get a new dashboard.
And all important this has to be ready 16th dec 2009.
So any suggestions will be taken on board.

Or you could just buy a 90Tdi??? Ive nothing against upgrading a series but when you have changed engine/gearbox/trans box/props/axels whats the point of having a series? Sell it and get a 90:crazy:

If you run into any problems fitting disco axles, try PMing TheSmiths88 (I don't think he's on here that often) - he's just fitted a front disco axle onto a IIA and it sounds like it was quite tricky because unless you make some alterations the track rod fouls the leafsprings apparently. As for the dashboard, I'm a bit tight, so I stripped off all the cracked plastic and foam from the upper dashboard and painted the steel structure underneath - it doesn't look too bad. I think you can get wiring looms from John Craddock.

As regards buying a 90 they cost to much money here in ireland.
Plus it will be 40 euros to tax the series 3 as it is over 30 years old.
it will be a series 3 with a twist.:bolt:

HI ALL
Just an up date bought a 200 tdi disco as my donor for running gear
I'll post pictures in a couple of weeks
So any ideas all are welcome
Dominic

Hey all
just an up date on the rebuild.
Got chassis from rj harvey shortened range rover chassis 93 200tdi disco axles and engine and drive train td5 bulkhead and 90 seat box. photos to follow
regards dominic