Repair rear sill advice

Hi guys,

My RR p38 is generally sound but there is some bubbling starting at the base of the rear door sill, the area of the rear arch where the door closes at the very bottom.

It's obliviously caused where the door seal rubs on the body or the odd stone chip but the question is how does one go about repairing it?

I'm sure it's still solid so no welding will be required but any advice on the fix?

I'm thinking scrape bad paint off and rub down. Then treat with good rust eater and when clean and dry prime and paint?

Any put falls removing anything from the area etc? Anyone done it?


Cheers

yeah thts about right. if its pitted you may need to fill it and make sure u use etch primer before any other.

As gazza
Just be sure you treat/ remove any rust otherwise it will come back

Thanks guys, going to order some vac-tan first as it's a very good rust treatment used in Vw camper circles.

Good news is not even as bad as I was thinking