bustersbus
Well-Known Member
- Posts
- 13,755
- Location
- Near Dumfries, Scotland
RENEWING AN INJECTOR PIPE.
Had a wee bit of seepage from the injector pipe union so decided to change the pipe.
Heres how ah did it
The pipes
Ah removed the hose from the cyclone breather to make it a bit easier to get to and tucked it out of the way
Then ah removed the two clamps that hold the pipes together
As it was number one pipe, ah found it easier to remove it from under the bus
Then back up top to undo and remove the pipe
The old and new pipe
Refitting is pretty much the reverse. Ah stuck the top union on by a couple of turns just to hold it before fitting the bottom.
Heres some photies of it going back in
Thats it, job done
Had a wee bit of seepage from the injector pipe union so decided to change the pipe.
Heres how ah did it
The pipes
Ah removed the hose from the cyclone breather to make it a bit easier to get to and tucked it out of the way
Then ah removed the two clamps that hold the pipes together
As it was number one pipe, ah found it easier to remove it from under the bus
Then back up top to undo and remove the pipe
The old and new pipe
Refitting is pretty much the reverse. Ah stuck the top union on by a couple of turns just to hold it before fitting the bottom.
Heres some photies of it going back in
Thats it, job done
