removing the front calliper
- Thread starter wjsmart
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
boydy1989
Well-Known Member
- Posts
- 3,063
- Location
- Northants/Oxfordshire/Warwickshire
They are twelve point bi-hex heads. Any multi point socket will fit (i.e. 12 points not 6) as long as it is the right size. From memory i think they are a 15 but im not certain, could be 13 or 17mm.
Trewey
Cockernee, Pasty munchin bastid.
- Posts
- 20,080
- Location
- Kernow - Near England
13mm
Griffdowg
New Member
- Posts
- 7,194
- Location
- Somewhere in Bristol
Ai, 13mm bi-hex. when you remove the disk from the hub, put the wheel studs back in the wheel on the floor, you will get more leverage on the bolts holding the disk then... that is if you dont have a vice, which i dont.
G
G
Similar threads
