Removing PSI powerbox

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
mcapinha

mcapinha

Active Member
Posts
549
Location
Portugal
Hi all.

I want to remove/disable my PSI powerbox. It came with the Rangie and it's one of the first models, that taps into the MAP sensor pipe.
Unfortunately I cannot find the fitting schematics anywhere so I'm in need of some help. What I would like to do is to just disconnect the power wire, probably inside the box, just to run with it disabled for a while.

Does anyone have any schematics for these boxes ?

Thanks in advance,
Manuel
 
On my PSI Powerbox there is a "floating" black wire (although documentation calls it a grey wire!) which can be earthed it then apparently switches the PSI Powerbox off.
Never tried it but have run the car without the box and its pants.
 
Datatek,
On mine it seems that it is connected to the wires but is not intercepting them, much like the hot start fix that splices some cables together. (I say seems because it looks like such a bad job that I'm afraid to go near it).

Grange,
Do you have that documentation available, can you send it to me by mail?
 
I read the FAQ section...so here goes.

Hope this helps.

PSI Powersport Docs.jpg
 
Grange Rover,
Thanks for you trouble! Altough it looks like those instructions are for a more recent version (mine has a T that intersects the tube for the MAP).
I'm still going to open it and look for the grey wire as that would achieve what I'm after.

Thanks once again :)
 
You must log in or register to reply here.

Similar threads

vizsla
Diesel heater
Replies
2
Views
564
Rougharse Racing
Rougharse Racing
H
Oh no! Not that old fog light question again.
Replies
14
Views
699
dag019
dag019
spacebrodie
Freelander 2 (LR2) Cut out - P0045-19
Replies
6
Views
823
Arctic2
Arctic2
J
Freelander 1 2004 TD4 airbag clockspring.
2
Replies
21
Views
2K
kernowsvenski
kernowsvenski
Maat
P38A A third way of changing the fuel pump
Replies
5
Views
1K
BDC
B
Back
Top