Relays
- Thread starter Tom Leech
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Flossie
Well-Known Member
- Posts
- 11,311
- Location
- Shropshire
200tdi doesn't have a starter relay AFAIK.
Glow plug relay?
Starter solenoid?
Glow plug relay?
Starter solenoid?
On the wiring diagram is says it does which is why i'm a bit confused, tried a relay that i thought may have worked and the engine started when turning the key to ignition not start
Gmacz
Well-Known Member
- Posts
- 968
- Location
- Forfar/Dundee
Take a pic of it and post on here, saves a lot of guessing.
None on a 200, if you look at the back of the ign switch the starter trigger wire is huge compared to modern cars
The diagram may be referring to the starter motor solenoid which is as youve guessed a relay.
Have you checked the starter itself, checked the battery positive and negative leads?
The little trigger wire terminal, (the same fatish one from the back of the switch) can and does come loose, right bar steward to get to in situ.
My 200 has had a few starters due to being dunked to often.
The diagram may be referring to the starter motor solenoid which is as youve guessed a relay.
Have you checked the starter itself, checked the battery positive and negative leads?
The little trigger wire terminal, (the same fatish one from the back of the switch) can and does come loose, right bar steward to get to in situ.
My 200 has had a few starters due to being dunked to often.
MeatCleaverX86
Active Member
- Posts
- 437
- Location
- Earth
Gmacz
Well-Known Member
- Posts
- 968
- Location
- Forfar/Dundee
There was another with this problem in the military section. Newest post ffr radio 90 i think, page2.
chris-the-gerbil
Well-Known Member
- Posts
- 994
- Location
- Leeds
Is that not the start stop relay for the fuel pump?
I'm pretty newish to land rovers so still getting my head round all the different bits.
What ever relay it is without it being fitted the startmotor solinoid won't work either,
The previous owner has done some dodgy wiring on it so trying to sort that out
Might be worth pulling the dash panel out, easy only a few screws, pop off the speedo cable with long nose pliers and take a squint at the back of the ign switch and see fi you can see the fat white wire with red tracer I think they are the correct colours and get testing from there.
Similar threads
