Rear tub supports - removal
- Thread starter Gun7354
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
Yes think so , I took mine off but this might help
www.landyzone.co.uk
Series swb rear tub
Going to try rebuilding the swb series 3 tub soon Got ali for floor and decent top hat and crossmembers Picked up rear quarters panels new and capping etc is good Problem is I’m replacing driver side rear wing. Picked one up with b pillar on it, so that should help But not sure on the spot weld...
www.landyzone.co.uk
Thanks SteveYes think so , I took mine off but this might help
Series swb rear tub
Going to try rebuilding the swb series 3 tub soon Got ali for floor and decent top hat and crossmembers Picked up rear quarters panels new and capping etc is good Problem is I’m replacing driver side rear wing. Picked one up with b pillar on it, so that should help But not sure on the spot weld...
steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
Also the easy option to remove bolts at rear to jack up 15mm to give clearance to get the steel supports out
steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
Mine rotted through where the steel supports touched the floor (electrolytic corrosion) so paint it well of use some thin insulation between them
