Rear lights loom

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

meego

Well-Known Member
Posts
11,057
Location
Caledonia
The wiring for my electrics is a mess. For the rear lights and indicators, it's all bullet connectors and spades of all sizes and colours and I want to tidy it up. Are there any multi plugs available that could be recommended, or any other suggestions. I'm not great with electrical issues.
 
Trailer cable is good for a rewire around the rear ,I use the chock block connectors folding the exposed bit of wire back over the outer for a good firm contact.
Just do not use those scotch block connectors,have seen many problems caused by those horrible things.
 
Years ago I used trailer cable to rewire the back end of a series 3.
I used a rubberlite (?) Connecter box, made of rubber with beefy brass terminals inside and a clear plastic lid. Quality item but it wasn't cheap and I had no internet then(most didn't) , so it was only what the local factors had.
 
Just buy a new one from autosparks.
THIS^^

If it is just for the rear loom they are reasonably priced and make a huge difference, no more earth faults and dog previous owner repairs. If you need a full loom i begins to get expensive however.
 
I would always fit new rather than repair, and you can have out outside of the chassis rail,
 
Back
Top