Rear door lock replacement

Al2O3 · Oct 17, 2015

I've bought a new rear lock handle mechanism as mine was shot.

How do I swap the barrel? There is a small hole in the side of the housing, but can't detect a grub screw. Any ideas?

Retroanaconda · Oct 17, 2015

It's just a pin that needs depressed to withdraw the barrel (with key inserted). Quite likely seized up.

Al2O3 · Oct 17, 2015

Almost certainly will be seized

At least I know what I'm trying to do now, cheers.

gazman · Oct 17, 2015

Have a look down the gap at the top of the lock looking down at the barrel so you are looking at the side of it (inside the lock handle mechanism) you will see a little brass nipple that needs pressing in. Once done it will remove on your key.

Google it for pictures. It really is simple

cowasaki · Oct 17, 2015

You can't swap the barrels! The new lock you got is the new style the old one is the old style. The barrels are not interchangeable.

EDIT: On closer look the new lock looks like it is a new old style one

Al2O3 · Oct 18, 2015

Cheers, lads. Amazingly, it was not seized! The pin compressed easily and the barrel just slid out. I put the barrel in penetrating oil over night. I'll see tomorrow if it fits new handle/mechanism.

terry taylor · Oct 18, 2015

Excellent don't forget pictures ..

Al2O3 · Oct 18, 2015

There you go Terry, though it's not the most exciting picture. It's blurry too

The penetrating oil must have worked on the tumblers, because they tapped loose reasonably easily. Worked them back and forth with a screwdriver and some oil , so they would spring in and out with the key.

terry taylor · Oct 18, 2015

Good job sir thank you

Rear door lock replacement

Al2O3

Well-Known Member

Retroanaconda

Well-Known Member

Al2O3

Well-Known Member

gazman

Well-Known Member

cowasaki

Well-Known Member

Al2O3

Well-Known Member

terry taylor

Member

Al2O3

Well-Known Member

terry taylor

Member

Similar threads