mrsnoops
New Member
- Posts
- 210
- Location
- Derbyshire
Hi all, was going to replace my rear discs today but to my surprise found the calliper mounting bolts were of the spline variety. Can anybody tell me what size they are? Snoops
Rear calliper bolts
- Thread starter mrsnoops
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
robint
Well-Known Member
- Posts
- 7,057
13mm ring spanner will fit them
bmp42
Active Member
- Posts
- 658
- Location
- Coimbra, Portugal
and the discs require a 14mm socket - 12 sided
mrsnoops
New Member
- Posts
- 210
- Location
- Derbyshire
Hi robint, thanks for your quick reply will try that tomorrow. They look pretty corroded & i was very surprised to find them fitted instead of a normal hex head bolt.
mrsnoops
New Member
- Posts
- 210
- Location
- Derbyshire
Again cheers bmp42 for your prompt reply, hopefully the calliper bolts will free off then i can finally replace the discs using your info ref. the brake disc bolts. Snoops
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Get a decent 13mm 12point socket. pref 1/2" drive and a big bar as they can be a tad on the tight side when you try to undo them
mrsnoops
New Member
- Posts
- 210
- Location
- Derbyshire
Hi redhand, will get a new twelve point socket tomorrow & give it a try. Fingers crossed
