Quick Alternator question

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
W

We5ley

New Member
Posts
254
Location
Wirral
just swapping my Alternator over and the connectors to the new on are different so going to pop the shops and by some hoop connectors.


20131005_111644 by Abhorsen The Final Death, on Flickr

I am guessing that i am just going to put the two thick brown wires to the one big nut on the right and single brown and yellow wire to the little nut on the left?

Just to be clear I am on about the two nuts inside the black plastic surround.


20131005_111657 by Abhorsen The Final Death, on Flickr
 
Ok next issue, new alternator does not have a pulley wheel on the front to mount the belt, and the old one even gripped in a vice when i turn it just turns and turns, relay hard to turn it but more feels like i am turning the hole unit to get it to trun, is the nack to getting the bolt undone to get it off, or would i just be easer to buy a new pulley wheel?

Its not like i can drive it atm, ether way with too falts atm, so dont mind waiting if i need to order a new bit?
 
We5ley said:
Ok next issue, new alternator does not have a pulley wheel on the front to mount the belt, and the old one even gripped in a vice when i turn it just turns and turns, relay hard to turn it but more feels like i am turning the hole unit to get it to trun, is the nack to getting the bolt undone to get it off, or would i just be easer to buy a new pulley wheel?

Its not like i can drive it atm, ether way with too falts atm, so dont mind waiting if i need to order a new bit?
Click to expand...

Air gun or alen key in spindle then belt the spanner with a hammer
 
2.5 NA I had put a scre driver up in to the fan bit and had it on the floor, to stop the fan bit spinning round, which stopped the rotating, but maybe that was not stopping the correct bit. Maybe it was just turning the hole spindle in side that.
 
I swapped my alt on my disco 300 tdi for one off a RRC i think it was... the connectors were different but if you look at the alt there r letters or symbols on the alt and i just matched them up and it worked... (i think) :)
 
You must log in or register to reply here.

Similar threads

F
TD5 Starter Wiring Question
Replies
12
Views
622
foggy23
F
Resurgam
Alternator connections
Replies
17
Views
1K
the-prince-e-paul
T
S
Glow plug power
Replies
10
Views
303
Singr07
S
J
Classic 1982 Range Rover 3.5 V8 CHARGING ISSUES
Replies
18
Views
839
Ratae
R
M
L-Series Alternator blocked by Power Steering
Replies
3
Views
608
GrumpyGel
GrumpyGel
Back
Top