I've been browsing the BBS site for info on the Nanocom Evolution for my DSE and found this: http://www.blackbox-solutions.com/downloads/vehicle_coverage/EDC.pdf . It shows an option called "Pump Calibration" under EDC Management / Diesel > Settings. Can someone tell me what this is for ?
Question about Nanocom's "Pump Calibration" option
- Thread starter mcapinha
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 45,775
- Location
- Near Poitiers SW France
Pump Calibration Idle settings? Just what it say's, you can adjust the idle setting to change the idle revs.
- Posts
- 58,170
- Location
- Preston Lancs.
If you change anything on that make sure you write down the original settings or you may end up with a can of worms. Don't change anything more than 1 or 2 points up or down. If that change has no effect set it to original. You are playing with fire.
- Posts
- 58,170
- Location
- Preston Lancs.
It is explained in the text what this function is for. However as far as i recall without looking at the Nanocom screen only the idle setting is annotated. All the other settings could be anything changing them would be a little hit and miss.
