bill0508shot
Member
- Posts
- 23
Hi new to this but have had many old discos. My current 300 is eating the rubber donuts on rear, since I changed the original which was only slightly cracked after 100k miles..What have I done?
Propshafts
- Thread starter bill0508shot
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Galen
New Member
- Posts
- 276
- Location
- Staffordshireshire
Did you change the centring bush along with the donut?
Davee
New Member
- Posts
- 79
- Location
- North Kent
Don't buy the cheap ones. They look the part, but are made out of old flip flops and last about 5 minutes.
Buy a proper GKN kit, comes with the centre bearing as well. The difference in quality will soon be obvious.
Buy a proper GKN kit, comes with the centre bearing as well. The difference in quality will soon be obvious.
bill0508shot
Member
- Posts
- 23
yes,on the previous which did 2000 miles and on the current, 20 miles so far
MrPDude
Active Member
- Posts
- 566
- Location
- Birmingham
Im selling a 200 prop and 4 bolt flanged diff if your nearby?
bill0508shot
Member
- Posts
- 23
yyes last time and this
bill0508shot
Member
- Posts
- 23
yes on this and the previous
bill0508shot
Member
- Posts
- 23
gkn this time and last.If this packs up will go for proshaft change.
Graham Carter
Active Member
- Posts
- 170
- Location
- Wantage, Oxfordshire
Is your UJ on the front of the propshaft OK? I can imagine that putting a strain on the donut if it's got problems...
Cheers!
Cheers!
bill0508shot
Member
- Posts
- 23
yes its fine.now done 40 miles and counting
