Propshaft repair

martin41076 · Sep 9, 2023

Hi All

Had a failure on the MOT for the propshaft.
VCU is fine but needed to replace universal joints and both centre bearings.
Took out the whole thing to work on in the garage to make it easier.
Replaced the UJs and the bearing on the rear propshaft no problems - came apart without too much effort.
bBut cannot get the front separated from the VCU where the UJ point is to replace the bearing.
Anyone else had this issue? Any suggestions?

GrumpyGel · Sep 9, 2023

martin41076 · Sep 9, 2023

GrumpyGel said:

Thanks for replying. Already tried that, rear came off as easily as the video, front just won't budge from the VCU. Soaked in WD40 to see if that would help but it just won't have it.

andyfreelandy · Sep 9, 2023

Important that the bolt is adjusted so that the cold chisel sits on both sides of the UJ or it won't work. Support the uj on a block of wood and sharp smack with hammer. Soaking will help.
Refit using copper grease or similar.

GrumpyGel · Sep 9, 2023

martin41076 said:
Thanks for replying. Already tried that, rear came off as easily as the video, front just won't budge from the VCU. Soaked in WD40 to see if that would help but it just won't have it.

You are either missing, or lacking in 1 component. Aggression.

It needs maximum aggression to separate. Tools need to be bouncing and flying around the garage to get them apart.

Alibro · Sep 9, 2023

martin41076 said:
Hi All

Had a failure on the MOT for the propshaft.
VCU is fine but needed to replace universal joints and both centre bearings.
Took out the whole thing to work on in the garage to make it easier.
Replaced the UJs and the bearing on the rear propshaft no problems - came apart without too much effort.
bBut cannot get the front separated from the VCU where the UJ point is to replace the bearing.
Anyone else had this issue? Any suggestions?

What do you mean when you say the VCU is fine? Have you tested it?

martin41076 · Sep 9, 2023

Thanks. Not through a lack of trying - as proven by the massive bruised lump on my hand (a mis-timed swing with the club hammer)

I've left it to soak in WD40 overnight and will go nuclear on it tomorrow.

martin41076 · Sep 9, 2023

Alibro said:
What do you mean when you say the VCU is fine? Have you tested it?

Yes, as had to replace bearings and UJs, wanted to check it first in case I needed to go for full replacement or I was lucky enough just to replace those bits

martin41076 · Sep 10, 2023

Hi All
Thanks for your advice.
Brute force alone didn't work.
Got a gas gun on it, heated it up and then gave it a few more whacks and hey presto!

Propshaft repair

martin41076

Member

GrumpyGel

Well-Known Member

martin41076

Member

andyfreelandy

Well-Known Member

GrumpyGel

Well-Known Member

Alibro

Well-Known Member

martin41076

Member

martin41076

Member

martin41076

Member

Similar threads