problems with clock

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
V

vyrnwyboi

New Member
Posts
3
Hi hoping someone on here can help me, ive recently replaced the clock in my landrover freelander and notice that with this one also when the ignition and engine is running the light is on but when i need it on at night ie when the lights are turned on it goes out, :confused::confused: any suggestions much appreciated
 
Ive checked the bulb and its fine its in the back of the clock, i just dont understand why it goes off when i put my lights on.
 
teddywood1 said:
mine does that it does not go off it just dims and so did my other one and so does the wife's
Click to expand...

same here , when i put my lights on its dims down along with the radio etc

wonder if its a bad bulb, as i assume its a double element , know when i took mine out a while back its just a small green bulb
 
I fabricated (great word for cutting and shaping plastic) a piece of plastic to fit the 2 LED thingys and then used a glue gun to stick that to the trim. I then pushed the LED things through and ran the cables where there needed to go. I took power from the existing light switch which is quite complicated as mentioned above there are several circuits for the light bulb- off. on, on with lights. Took quite a while to work out which contacts to use, and the only way for me in the end was to wire it to the light circuit, so to see the clock, I need my side lights on all the time. As I have CREE LEDs which I use as DRL's it isn't a problem.
 
You must log in or register to reply here.

Similar threads

J
Freelander 2
Replies
5
Views
699
Arctic2
Arctic2
T
Rough Idle (holding on breaks)
Replies
6
Views
1K
BIGrabbit100
B
S
Clock wiring
Replies
5
Views
1K
Stanleysteamer
Stanleysteamer
T
Freelander 2
Replies
2
Views
636
Stv123
Stv123
R
Disco 2 Dash back lighting and switch illumination issue
Replies
8
Views
2K
sierrafery
sierrafery
Back
Top