p38

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Don’t think you would like the price unless you are gonna be using it every month.
Do a search on u tube, there are a few methods to get around it.

what exactly are you replacing to think you need it?

J

oh welcome:)
 
hy i changed the ball joints and since then the driveshaft oil seals leak tryed new ones tryed every method i can find on youtube and still they leak oil
 
You could try undoing the hub a touch while leaving the cv joint bolted into place and slide the hub and cv assembly out a little so the disk on the shaft allows you to just see behind it and check the shafts height in relation to the seal.
The coller under the bottom ball joint nut raises and lowers the hub carrier.
The lower ball joint has to be loosened and the taper popped to be adjusted.
As a rule you leave the collar as found from the factory. Most seals will leak from age. ;)
 
I made something up from utube make sure you drill hole through it to keep it all tight in the axle
 

Attachments

  • image.jpg
    image.jpg
    391.3 KB · Views: 79
Oh I remember wammers had a post where he machined a tool for the job mines probably not exactly to his specs but then again I couldn’t build planes I wish I could have had some of his knowledge at least that way I wouldn’t have to centre that joint again hopefully all be good when the wheels are back on and running
 
Can’t go near it now he av my bloody hand off
 

Attachments

  • 905F28B9-49D8-47CD-A690-F5677A8B9A7D.jpeg
    905F28B9-49D8-47CD-A690-F5677A8B9A7D.jpeg
    464.4 KB · Views: 69
  • 47CD6C56-3A7C-4D1F-8F6D-E8EED8B9D052.jpeg
    47CD6C56-3A7C-4D1F-8F6D-E8EED8B9D052.jpeg
    474.4 KB · Views: 78
was thinking of making the tool up before i strip it down again to avoid having to run about finding tubes and wheel bearings while its in bits thats all
 
You can buy the tool it’s about £1000 now the 1st video is on u tube in the column down the side of the video that plays 1.1/2 inch tube 65mm bearing and race job done
 
Back
Top