Hi I have just purchased a P38 2000 RR..... the air suspension has been removed and coils and springs fitted... I have just started getting the EAS fault warning and 35 mph max warning.... I've checked fuses and replaced the air suspension overide module... Can clear the fault withT4 no fault codes show but the warning returns after a short while.... Any suggestions or advice greatly received thanks
P38
- Thread starter Paul9399
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Shimsteriom
Master Procrastinator
- Posts
- 41,905
- Location
- Over Here
Welcome to LoonyZone 
saxavordian
Well-Known Member
- Posts
- 9,349
brianp38dse
Well-Known Member
- Posts
- 20,094
- Location
- heathrow
Hello and welcome
Thanks v muchWelcome to LoonyZone
- Posts
- 33,921
- Location
- North Shropshire
Hi and welcome
Sorry to hear your steed has been castrated
Sorry to hear your steed has been castrated
Yeah thinking of reinstalling all the gubbins are still there and although it's 20 years old... Its only done 45k....it would be nice to have it all original.... Just hoping for a fix to stop the bleeping cheersHi and welcome
Sorry to hear your steed has been castrated
- Posts
- 33,921
- Location
- North Shropshire
Could just be a bad connection somewhere so it doesn't always see the override?
Unplug the beeper
Unplug the beeper
Could it be a relay?Could just be a bad connection somewhere so it doesn't always see the override?
Unplug the beeper
- Posts
- 33,921
- Location
- North Shropshire
The system isn't really that hard, so long as you can understand that it's only compressed air and not some magic fairy dust
- Posts
- 33,921
- Location
- North Shropshire
There's a relay in the main fusebox, they can go bad, swap with another and see if the fault moves.
I'm guessing there was a fault to cause the PO to put it on coils, which could have burnt the relay etc
Hi sorry for delay.... Just looked that relays not there.... I'm presuming it's never been there and fault has only come on recently... So any other tjoughts
RangeRoller dt
Well-Sprung Member
- Posts
- 14,411
- Location
- Trapped inside my head @ LZ asylum
Your override isn’t working. EAS relay 20 in engine compartment fuse box should be removed.
Should say ‘beep beep beep EAS manual’. 35mph Max means its aware the EAS is still there and recognises fault.
There should be a (5A?) fuse on the overide probably that. Depends how it was done. Worst method is if they chop the becm connections that’s asking for trouble.
Welcome to the palaver
Should say ‘beep beep beep EAS manual’. 35mph Max means its aware the EAS is still there and recognises fault.
There should be a (5A?) fuse on the overide probably that. Depends how it was done. Worst method is if they chop the becm connections that’s asking for trouble.
Welcome to the palaver
Hippo
Lord Hippo
- Posts
- 53,952
Ask in the rr section below for a quicker response. They're ok in there... but try not to make eye contact with them.
Range Rover:
https://www.landyzone.co.uk/forum/range-rover.10
Range Rover:
https://www.landyzone.co.uk/forum/range-rover.10
