kernowdragon
Well-Known Member
- Posts
- 1,918
- Location
- Wickford, Essex
Any one know the part number for the oil cooler hose o-ring seals (rad end) on a P38 DT manual, my local stealer seems incapable of working it out!
P38 oil cooler seal part numbers
- Thread starter kernowdragon
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
Get them from a bearing stockists or even buy one of those assorted "O" ring kits. They are only standard "O" rings, nothing fancy.
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
Petrol is ESR1549L (4 of them....same both ends)
Diesel is ESR2237 ( " " " ")
Diesel is ESR2237 ( " " " ")
kernowdragon
Well-Known Member
- Posts
- 1,918
- Location
- Wickford, Essex
Cheers Irish, I tried the generic o-ring route but although they where the right diameter they were too thick in x-section, so had to take the stealer route, but they were positively unhelpful.
