Tomp384.6
New Member
- Posts
- 2
- Location
- portsmouth
i’ve recently rebuilt the engine after head gasket failure, done everything as normal, i rebuilt one a while ago and that started straight up, this one doesn’t seem to want to,
new timing chains, all gaskets and everything replaced,
so i had an engine disabled message on the dash, i did the programming thing in the door lock, and got rid of the message,
the engine turns over but doesn’t seem to want to fire, i’ve seen a lot on other forums about fine tuning the fuel pump but am not sure on how that is done,
i’m unsure on what else it could be as it all turns over fine and it all ran before changing head gasket
new timing chains, all gaskets and everything replaced,
so i had an engine disabled message on the dash, i did the programming thing in the door lock, and got rid of the message,
the engine turns over but doesn’t seem to want to fire, i’ve seen a lot on other forums about fine tuning the fuel pump but am not sure on how that is done,
i’m unsure on what else it could be as it all turns over fine and it all ran before changing head gasket
