Hi, the car is at normal ride height when you stop/switch off, as soon as you restart you get the all lights on pre check as normal then solid light for normal height but the disembark is flashing as if you had pressed to lower and the car starts to lower, if you go into drive/reverse or touch the raise button the disembark light stops flashing and the car stays at the normal ride height, if you don't select drive/rev raise button straight away and it has already lowered slightly it immediately returns to normal height as soon as you select drive/rev etc. Can't see it being a pressure problem, as soon as you start up and gone into drive/rev or pressed the raise to stop it lowering if you press raise again it goes straight up to wading height in a couple of seconds max, tried it with the inhibit in prior to starting and also inhibit in before stopping but it makes no difference the bottom light starts to flash and the car goes down to disembark unless you stop it as mentioned earlier, if you allow it to go all the way down, the bottom light goes solid and the the normal goes out, press up button normal ride height ind flashes and the car comes up in a few seconds, normal goes solid and bottom goes out. The suspension works exactly as it should ride height change for motorway/speed etc plus all manual button selections it just started lowering to the bottom every time you start unless you intervene, its not an over night thing you can stop and start the car as many times as you want but the second self check is done it flashes for down unless you stop it