P38 Glow Plugs

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
W

wantaquad

Active Member
Posts
306
Hi,
Could someone recommend a make and supplier of Glow plugs for a 1996 2.5 DSE please.
Don't want to risk fitting a set that won't last

Cheers :D
 
dunno m8,give em a bell and ask em i suppose.
suppose as long as they arn't britpart you wont go far wrong
 
I just fitted bosch,£7,50 each from Andrew Paige Factors, also got a set of leak off pipes £5,OO. Not sure of your location .they are in the North West, mine now starts bang on the button. hope this helps.
 
hi,
as far as i know the make of glow plugs fitted to the RR diesel when manufactured are BERU, i got mine off EBAY for around £50.
all the best kevin
 
RR Qatar said:
I just fitted bosch,£7,50 each from Andrew Paige Factors, also got a set of leak off pipes £5,OO. Not sure of your location .they are in the North West, mine now starts bang on the button. hope this helps.
Click to expand...

Andrew Paige supposed to be TRADE factors. But any Tom Dick or Harry can go in and get TRADE prices. Problem is their TRADE prices are extortionate. If you have them near you Partco or Dodgesons are much cheaper for same stuff. If your in the trade that is.
 
Hello.. I got some off fleabay .. Ngk brand.. been in 9 months now and not a problem so far...
 
paddocks1967 said:
you can get beru plugs from german swedish,for about 55 quid.
Click to expand...

German Swedish known as GSF because they've added French to the list!
The engine is BMW M51 and you can get various bits for that engine from them, inlet manifold gaskets, glow plugs, leak off pipes are just 3 but beware some external parts on the engine are different on the Range Rover.

Are you sure your problem are the glow plugs? I wondered about mine as it needed two or more goes of preheat to get it to start, then I purchased a one way fuel valve and put that in the fuel supply circuit after the filter and I now have an engine that fires up after one hit of the glow plugs! With wear, fuel drains back and creates an air lock, the one way valve stops that happening. Total cost £12 including 8mm valve and new 8mm fuel pipe and 4 clips. Hardest part is carefully cutting the old, very hard, fuel pipe off the plastic elbow on the fuel filter. Time for job 1 hour.
 
Island 4x4 have Beru at £8.50 and "Glow Heater Plug P38 2.5TD STC3103" for £3.69

Anybody know if the cheap ones are any good?
 
I would recommend that you do not fit cheap' ones.

My garage did and they feel apart in the engine. The ceramic casings broke up.

Ceramics and Piston rings don't mix well.
I would only fit Bosch or Beru (Beru are original equipment) from a reputable supplier, another £30 is far cheaper than an engine rebuild after scoring your liners and breaking a ring or two!
 
Greenrover said:
I would recommend that you do not fit cheap' ones.

My garage did and they feel apart in the engine. The ceramic casings broke up.

Ceramics and Piston rings don't mix well.
I would only fit Bosch or Beru (Beru are original equipment) from a reputable supplier, another £30 is far cheaper than an engine rebuild after scoring your liners and breaking a ring or two!
Click to expand...

I have never seen a glowplug with ceramic casings. There may well be a ceramic insulator in there somewhere but the casing and glow tip are steel.
 
You must log in or register to reply here.

Similar threads

ibizalandy
'86 110 2.5d. 9v at glow plugs.
Replies
4
Views
609
tottot
tottot
G
P38A Glow plug relay fuse
Replies
4
Views
813
Grrrrrr
Grrrrrr
E
P38A Is this the head gasket?
Replies
12
Views
1K
Grrrrrr
Grrrrrr
T
Testing and changing the glow plugs on a TD5
Replies
11
Views
670
Twinnie
T
S
Glow plug power
Replies
10
Views
1K
Singr07
S
Back
Top