P38 Drivers door problems

J

Jasonmotors

New Member

Posts

1

• Jan 24, 2011

• #1

Hi Guys,
My P38 battery went flat, I charged it back up but when I started the car it has now lost all uses's on the drivers door, car thinks door is open all the time, the interior light stays on all the time, electric wiunder doesnt work and the air suspension is froze

I have changed the door lock and out station, but made no difference

any ideas much appreciated
Jas

 

S

sandyt

Well-Known Member

Posts

1,615

Location

Wraysbury Nr Heathrow

• Jan 24, 2011

• #2

Welcome to the loony bin can you put in where you are and which motor it all helps does the central locking work off the fob or the key on any of the doors?

 

S

sandyt

Well-Known Member

Posts

1,615

Location

Wraysbury Nr Heathrow

• Jan 24, 2011

• #3

Sorry also what happens when you push the sill buttons on each front door

 

bushmanpm

New Member

Posts

225

• Jan 24, 2011

• #4

Probably gonna have to take it to a dealer or indie garage and get the diagnostics plugged in to reset everything. This should cure all the problems, any that remain will require further investigation.
Basically the car's computer is protecting itself due to the discharge & disconnecting of the battery so a simple resetting should put it all straight.
Good luck

 

S

sandyt

Well-Known Member

Posts

1,615

Location

Wraysbury Nr Heathrow

• Jan 24, 2011

• #5

All the functions you mentioned are controlled by the becm this does not hold any hard faults have you checked the signals in the loom from he becm to the outstation then from outstation to actuator