P38 1997 clutch slave

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
James hyett

James hyett

Member
Posts
89
Location
Abertillery
Hi all don't suppose anyone has a clutch slave for a 2.5 and are near abertillery Wales please mine just gone and relly need to get it back up and running thanks
 
Foundry4x4 in Tredegar have got them on fleebay for £16 there close to you but not open till the 3rd January, my be the quickest option. unless there is someone closer with an old one.
 
brianp38dse said:
Foundry4x4 in Tredegar have got them on fleebay for £16 there close to you but not open till the 3rd January, my be the quickest option. unless there is someone closer with an old one.
Click to expand...
Yeah I use them but I could really need to be back on road asap as I am on call and at the mo can't do anything but thank you so much happy New Year
 
Ok did it suddenly hit the floor when pressed and stay down, when you get it off try moving the arm it pushes if it moves round further than it should and the piston on cylinder has pushed out you may well have suffered the dreaded roll pin failure.
 
Well I only put the clutch slave on the 10 of this month I have just taken it off and the arm on the box seems OK there was no Real movement
 
Strange for one to go that new, had the piston come out off the cylinder, as that would indicate to much travel.
when my roll pins went the first time I went to leave a garage and pedal hit floor and stayed there managed to hook pedal back up and all was well for a week or so then again it went all I can think is the broken pin parts drop back in for a bit.
 
I thought it first the pin but when I seen the fluid peeing out the passion was not out to much and the clutch bar dose not seem to move that much so I pull out the passion and the rubber is really bad I'll put a pic up bear with me
 

Attachments

  • IMAG0026.jpg
    IMAG0026.jpg
    245.6 KB · Views: 90
I think Brian is right, check the release lever and I think you will find the clutch release fork roll pins have sheared.fitting a new slave cylinder will not help, it's a gearbox out job I'm afraid.
 
Just started on the **** lol but like I say.
rubber not good had a chunk missing out of it but if I am wrong I'll suffer it and I'll make the biggest apologie
Lol
 
Last edited:
You must log in or register to reply here.

Similar threads

Boxer
Clutch slips........and then it doesn't!
Replies
6
Views
533
Stanleysteamer
Stanleysteamer
M
New clutch but still not engaging flywheel
Replies
4
Views
543
miktdish
miktdish
T
Series 3 New "ticking" noise upon acceleration (in gear only)
Replies
3
Views
288
steve2286w
steve2286w
C
Clutch slave cylinder leak
Replies
4
Views
499
Mark Piercy
Mark Piercy
S
Clutch problems please help
Replies
5
Views
709
Si1979
S
Back
Top