finaly got most of my jobs on range rover done this week but still cant get her to stop overheating it will tick over all day long no overheating as soon as it s driven for a few miles temp gauge rises stop open cap slightly and pipes go soft again off it goes but no hot air inside car and matrix pipe is cold as is pipe coming out of stat at bottom of rad and has poor ciculation runs mint sounds realy quiet no misfire
overheating
- Thread starter shrek1972
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 43,980
- Location
- Near Poitiers SW France
Airlock, stat stuck closed, RAD silted up. Take your pick.
Datatek
Well-Known Member
- Posts
- 43,980
- Location
- Near Poitiers SW France
As a first step make sure the pipe from the top of the RAD to the expansion tank is clear. then do a site search as it has been covered many times.
Forgot to add a duff water pump is another possibility.
finaly got to the bottom of my rangeys overheating problem
bought new thermostat fitted it still same prblem then took rad of flushed it out dropped it and snapped top hose bought a good second hand rad flushed it out and still same so last chance was waterpump got new one and started to remove old one only to find out impeller fell of as i took it off engine fitted new one and runs a dream got her moted today new crentre section exhaust taxed her and now it runs and drives realy well very happy with it just a few minor jobs to finish now thanks for all you peoples help m
bought new thermostat fitted it still same prblem then took rad of flushed it out dropped it and snapped top hose bought a good second hand rad flushed it out and still same so last chance was waterpump got new one and started to remove old one only to find out impeller fell of as i took it off engine fitted new one and runs a dream got her moted today new crentre section exhaust taxed her and now it runs and drives realy well very happy with it just a few minor jobs to finish now thanks for all you peoples help m
sas1810
New Member
- Posts
- 1,347
- Location
- back in Willenhall, West Midlands.
was it a ****part you fitted before? plastic or steel impeller?
kevwill
Active Member
- Posts
- 930
- Location
- Sunny Hastings
Also worth checking the viscose fan coupling. Waterpumps I've replaced on 2 cars both needed new coupling as well.
P38Al
Member
- Posts
- 84
- Location
- North East Wales
Island 4x4 sell a nice new water pump with proper metal impellar! Far better than the plastic version which falls off the shaft or falls to bits after a few years.
