overheating paranoia

Wurzol · Oct 23, 2014

I have a 97 P38 4.0 SE is a good one FSH and one very careful owner who maintained it well at same garage for 17 years . i have done 10k in it and all good on the mech front but recently had a little fluid leak which was cured with some additive but am I advised to change the Rad just in case or am I being paranoid about overheating probs .

as far as I know it never has overheated but has done 159k on same running gear so rad might be getting blocked right ?

Littelwill · Oct 23, 2014

Where was your leak coming from?

Datatek · Oct 23, 2014

If you put RADWELD or such like in it you are asking for trouble, the radiator cores are very fine and easily blocked.

martynv8 · Oct 23, 2014

First thing i did when i got mine on 100k was change the rad, waterpump (metal impeller) & coolant. It had a very slight leak from the rad that was hard to find.
+1 on the additive (kseal?). This will block your rad & matrix sooner or later.

Wurzol · Oct 23, 2014

Oh dang yes was k seal that was bad advice I was given from someone in trade then doh !! Not sure where leak was it was very small hence k seal ! Ok think new rad and flush out is order of the day then

Thanks for the advice

Saint.V8 · Oct 23, 2014

As above....flush out the cooling system, fix the leak correctly and never use leak stopper additives....

Wurzol · Oct 23, 2014

Yeah leant the lesson there thanks slap wrist lol

Booking in tomorrow

overheating paranoia

Wurzol

New Member

Littelwill

Well-Known Member

Datatek

Well-Known Member

martynv8

Well-Known Member

Wurzol

New Member

Saint.V8

Dyed-in-the-wool 100% RR Junkie

Wurzol

New Member

Similar threads