Osculati boat hatches

retneprac

Well-Known Member

Posts

2,034

Location

Bedfordshire

• Mar 20, 2019

• #1

Anyone familiar with these type of plastic hatches?
Plan to use one for side rear arch access to my cabin heater.
Not sure what kind of plastic it is, wondered if anyone knew as would like to paint it, so need to chose the correct primer.

Cheers all.

 

kevstar

Well-Known Member

Full Member

Posts

23,062

Location

In the next Glen

• Mar 20, 2019

• #2

Probably uv basf luran s plastic

 

retneprac

Well-Known Member

Posts

2,034

Location

Bedfordshire

• Mar 20, 2019

• #3

Er, what primer might work with that type?

 

kevstar

Well-Known Member

Full Member

Posts

23,062

Location

In the next Glen

• Mar 20, 2019

• #4

retneprac said:

Er, what primer might work with that type?

Click to expand...

Ive never painted any hatches but have a look at Glasurit 151-170 UV PRIMER looks as if it may do the job.

 

R

Ratae

Well-Known Member

Posts

3,272

• Mar 21, 2019

• #5

There's a few primers specifically for use on car plastics to improve paint adhesion. Some are available in aerosols which would save you the bother of a spraygun.
The Glasurit one above is an ultraviolet lamp cured general primer filler which dries clear & the TDS sheets for it advise that on plastics it should be applied after their 1k Plastic adhesion promoter primer Glasurit 934-10-1k-plastics-primer.
www.glasurit.com/uk/products/glasurit-934-10-1k-plastics-primer

U-Pol do 'Plast-X' in an aerosol
www.u-pol.com/uk/en-uk/product/upol/aerosols-uk/plastic-bumper-repair-aerosols/plast-x-plastic-adhesion-promoter#.XJNgxyj7TIU

That said, these are intended for use on plastics used in cars so you might want to email Osculati for their advice.

 

retneprac

Well-Known Member

Posts

2,034

Location

Bedfordshire

• Mar 22, 2019

• #6

Thanks for that, cheers.

 

ogb

Active Member

Posts

289

Location

Moray, NE Scotland

• Mar 23, 2019

• #7

Used these for side lockers on 2 Defenders now. Very good alternatives to the v expensive metal jobs. Used a plastic primer and cellulose topcoat. Some support underneath is needed for heavy load use.
You might want to think about how you mount the doors. I've found it best to put the locks at the top so the door opens downwards. The other way might seem better, but stuff can migrate inside the locker and jam the locks.

 

retneprac

Well-Known Member

Posts

2,034

Location

Bedfordshire

• Mar 24, 2019

• #8

Great advise thanks. Mine is access to a cabin heater that's being mounted in an ali box that's getting fitted behind the rear wheel high up in the void.