O ring videos

Grit Valve · May 27, 2013

I just love this chap a bit heavy handed at times .

I'm sure you would grunt like this too

enjoy
1 Range Rover P38 O Rings Replacement Procedure Heater Core Exchanger Part 1 - YouTube

2 Range Rover P38 O Rings Replacement Procedure Heater Core Exchanger Part 2 - YouTube

3 Range Rover P38 O Rings Replacement Procedure Heater Core Exchanger Part 3 - YouTube

gencybay · May 27, 2013

I'm impressed. It's a question of when I thank him rather than if.

What a nice thing to do. Add filming to what seems a pig of a job just to help other people.

G~

wammers · May 27, 2013

Something to note is, if you noticed the cutouts in the ends of the pipes, they have to engage on locators in the matrix to orientate the pipes. The pipes may need twisting to fully engage them, if they are sitting on top of their location pegs, no amount of tightening of the screw will seal the O'rings.

stjohnsmythe · May 27, 2013

Top bloke for posting that!

sas1810 · May 27, 2013

Now I know why I have a hole in the side of mine. Looks like mine have already been done. But give him his due, not easy holding a camera and working.

anorakmark · May 30, 2013

Quick question, I noticed the battery was connected as the footwell light was on. The airbag loom was removed from instrument cluster and the air bag dud not fire. I need to remove my cluster and was advised to disconnect battery in case airbag detonates or is it safe to do with ignition switched off. Last thing I want us an air bag going off on me.

Grit Valve · May 30, 2013

anorakmark said:
Quick question, I noticed the battery was connected as the footwell light was on. The airbag loom was removed from instrument cluster and the air bag dud not fire. I need to remove my cluster and was advised to disconnect battery in case airbag detonates or is it safe to do with ignition switched off. Last thing I want us an air bag going off on me.

You can but why risk it its not a problem taking of a battery .

doz · May 30, 2013

I tried doing my O rings. Bloody screw won't move. Looks like I'll betaking the dash out

anorakmark · May 30, 2013

Hammer & chisel mate, usually works. I bottled it with mine and went to London Range Rover independent, their the dog's bollox, cost me just over £200 inc fitting of new hevac bulbs. They done an excellent job.

Grit Valve · May 30, 2013

doz said:
I tried doing my O rings. Bloody screw won't move. Looks like I'll betaking the dash out

Try soaking it for a couple of days with penetrating fluid before you round it off.

O ring videos

Grit Valve

2000 4.6 Vouge

gencybay

gatvol

wammers

No longer with us, RIP

stjohnsmythe

Active Member

sas1810

New Member

anorakmark

Active Member

Grit Valve

2000 4.6 Vouge

doz

Active Member

anorakmark

Active Member

Grit Valve

2000 4.6 Vouge

Similar threads