Hi all new on this, I have a question, my mechanic removed my auto box on my 4.0 p38. It was to fix real crank seal that was leaking badly. He replaced the box back in situ. Long story shorter!!! It’s not selecting gears. The selector in the cab isn’t very tight, seems sloppy. It reversed after job and drove back in but next day it won’t select gears. Can anyone shed ideas or light on the problem.
Not selecting gears
- Thread starter Mark tate
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
saxavordian
Well-Known Member
- Posts
- 9,347
Welcome aboard the SS landyzone for naked wine producing with Landrovers.
Would be worth asking on the range rover section for a better answer.
What was the condition of the autobox oil did they replace it and if so how much.
Would be worth asking on the range rover section for a better answer.
What was the condition of the autobox oil did they replace it and if so how much.
saxavordian
Well-Known Member
- Posts
- 9,347
If you do change the oil make sure a fresh filter added also. Normally the colour cherry red any duller or brown it's past it usefulness.
- Posts
- 33,879
- Location
- North Shropshire
Hi and welcome
Does it show a gear on the dash? Maybe it's come disconnected from the xyz switch
Does it show a gear on the dash? Maybe it's come disconnected from the xyz switch
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
Hello and welcome 
An update , my drugged up mechanic who did a weld on my exhaust didn’t disconnect my battery leads!(long story) but I was told by the guy in the unit next to where he was based! (Now kicked out)
So I plugged it in to diagnostic tool and I got this wiring regulator control selonoid!!! Is this the box under the passenger’s seat??? PCM ????
So I plugged it in to diagnostic tool and I got this wiring regulator control selonoid!!! Is this the box under the passenger’s seat??? PCM ????
No I check
ed it’s all fine
Nothing on dash
Sounds like yo have a few dodgey mech around you.
Post in the Range Rover | LandyZone - Land Rover Forum sexion
Am sure many will say the guy that replaced the box screwed up locating the TQ. and the welder needs a couple of jump leads connecting to some delicate parts of his body.
J
Post in the Range Rover | LandyZone - Land Rover Forum sexion
Am sure many will say the guy that replaced the box screwed up locating the TQ. and the welder needs a couple of jump leads connecting to some delicate parts of his body
.J
