Newbie
- Thread starter kinkade
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Shimsteriom
Master Procrastinator
- Posts
- 41,905
- Location
- Over Here
Welcome to the forum
We'll be needing some piccies of your car
We'll be needing some piccies of your car
- Posts
- 9,036
- Location
- Solent
And your address
1988smithy
Well-Known Member
- Posts
- 4,048
- Location
- West midlands
Hello and welcome
Hi all have just started to replace the height sensor on a disco 2 (nightmare) bolts corroded and the one on the radius arm has sheared so i decided to drill it out and now the drill broke inside the hole so at the moment i have a zip tie holding the sensor arm in place any ideas? i also noticed the bush on the front of the arm is perished is it worth getting a new arm or just remove and replace all the bushes?
RangeRoller dt
Well-Sprung Member
- Posts
- 14,411
- Location
- Trapped inside my head @ LZ asylum
You’ll have to drill it out and replace. Or drill new holes and bolt it on - same effort.
Start off with a small pilot bit and don’t press too hard let the drill do it’s thing. Let it cool now and again. Once you’re through move to a bigger bit. They’ll have to be quality bits.
Don’t go mad like I did
Best advice would be in the Disco section
Start off with a small pilot bit and don’t press too hard let the drill do it’s thing. Let it cool now and again. Once you’re through move to a bigger bit. They’ll have to be quality bits.
Don’t go mad like I did
Best advice would be in the Disco section
