Manual-auto air intake manifold same?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Jet 123

Member
Posts
58
Location
Scotland
hi I have a spares freelander td4 facelift that is a auto and my freelander is a pre facelift td4 Manual
I want to clean the air intake so my
Idea is take the one from the auto get
It really clean so I can just take mine off and replace straight away just to make the job quicker question is will it fit and should I clean or replace anything else when I am at it thanks
 
Yes the manifold is the same on the M47 Auto or Manual, use engine degreaser & or oven clean spray foam, scrape most of the black gunk out first, then give it a good soaking in the oven cleaner or engine degreaser, after being soaked for at least 4 hours jet wash the manifold out until clean.

You will need to clean out your EGR that is if you do not have a bypass one fitted at the moment, when you take off your old manifold, remove the MAP sensor give that a good wipe over with a rag with some carb cleaner on it, make sure you clear any gunk cogging up the hole in the MAP sensor, do not poke anything inside of the MAP sensor,

The EGR can be scrapped out with an old hacksaw blade use the back part of the blade not the teeth part to do the scrapping, wipe out with rags, and spray carb cleaner, into the EGR but not down the pipe, the rubber gaskets can be wiped as clean as possible and re-used.
 

Attachments

  • SDC10383.JPG
    SDC10383.JPG
    218.1 KB · Views: 95
  • SDC10384.JPG
    SDC10384.JPG
    216.8 KB · Views: 72
  • SDC10386.JPG
    SDC10386.JPG
    163.4 KB · Views: 69
  • SDC10387.JPG
    SDC10387.JPG
    180.1 KB · Views: 114
  • SDC10388.JPG
    SDC10388.JPG
    420.3 KB · Views: 97
  • SDC10389.JPG
    SDC10389.JPG
    260.5 KB · Views: 87
  • SDC10390.JPG
    SDC10390.JPG
    244.7 KB · Views: 78
  • SDC10404.JPG
    SDC10404.JPG
    249.4 KB · Views: 97
  • SDC10406.JPG
    SDC10406.JPG
    345.1 KB · Views: 100
  • SDC10409.JPG
    SDC10409.JPG
    164.8 KB · Views: 98
  • SDC15058.JPG
    SDC15058.JPG
    131.3 KB · Views: 110
  • EGR 2.JPG
    EGR 2.JPG
    376.3 KB · Views: 88
  • SDC10423.JPG
    SDC10423.JPG
    352.7 KB · Views: 81
hi thanks very much for taking the time to give such a in-depth reply with pictures
It will prove invaluable as I am new to freelanders would you advise EGR clean or blanking thanks again for your time
 
hi thanks very much for taking the time to give such a in-depth reply with pictures
It will prove invaluable as I am new to freelanders would you advise EGR clean or blanking thanks again for your time

Personally I would stick with cleaning it bypass ones can sometime throw up a bit of trouble but not always, once it is clean it does not take much to wipe it out every 6 months
 
Thanks for speedy reply yes I think I will clean it out this time as I have a mot in few months anyway going to strip the manifold out and get it steeping once again thanks for your help
 
Back
Top