LR 90 Engine to flywheel housing gasket?

lasher99 · Apr 7, 2024

Just a quick question, hopefully someone can help.
I'm in the process of replacing the rear main oil seal on my 19J, and was wandering if ;
a. anyone has any tips as regards fitting one so I don't balls it up.
b. Is there supposed to be gasket between the block and the flywheel housing, there wasn't one fitted previously and I can only see a replacement for the 200tdi ?
Any help greatly appreciated.
Lasher

tottot · Apr 7, 2024

Should have a gasket, part no ERR1440 [ same as 200]
Go to Turner Engineering for quality OEM parts, seal is ERR2532.
This is the same as original Dowty made seal.
Seal and crank surface have to be dry when fitted [ no oil].
I like to fit seal to housing on the bench and then fit housing to block having already fitted gasket to block [ gasket has sealant pre applied] using the plastic guide supplied.
Last seal I did was rather tight to go in housing so it spent an hour in the freezer before pressing squarely in place. Take your time and do it right. Cheers.

lasher99 · Apr 7, 2024

tottot said:
Should have a gasket, part no ERR1440 [ same as 200]
Go to Turner Engineering for quality OEM parts, seal is ERR2532.
This is the same as original Dowty made seal.
Seal and crank surface have to be dry when fitted [ no oil].
I like to fit seal to housing on the bench and then fit housing to block having already fitted gasket to block [ gasket has sealant pre applied] using the plastic guide supplied.
Last seal I did was rather tight to go in housing so it spent an hour in the freezer before pressing squarely in place. Take your time and do it right. Cheers.

Thanks tottot will check out them parts and the useful tips.

LR 90 Engine to flywheel housing gasket?

lasher99

Member

tottot

Well-Known Member

lasher99

Member

Similar threads