landrover 130 - centre exhaust removal on a 130

Im after removing the central exhaust silencer on the 130 (200tdi) to attempt to free up some power (it all helps!) and give it a slightly fruitier exhaust.

Am I correct in thinking the central exhaust on a 110 is the same, and its just extended with an additional bit o' pipe for the 130?

Im thinking of Terrafirma part TF563. as the replacement.

http://www.ribblevalley4x4.com/allmakes/AM_TF563.html

I am not sure which section of the exhaust they would have extended for the 130. My 110 resonator had a hole when I got the landy, so I cut it out and MIG welded in a piece of exhaust pipe. If you need any measurements to confirm, I can measure my center section and let you know.

.

.

I would think that the center section would be the easiest part for them to make/modify to fit the 90,110 and 130. If you can get a measurement, I can do the same here.

Cheers I'll measure up when I get in on Friday

Ive just realised I have a spare rear exhaust section in the garage, so I will fit that on the back (as its new), cut off the middle box at the front, then use the straight bit from the old exhaust to make up the missing bit.... if you see my logic.

60 notes saved.

#tightasfook

vilguy said:

Ive just realised I have a spare rear exhaust section in the garage, so I will fit that on the back (as its new), cut off the middle box at the front, then use the straight bit from the old exhaust to make up the missing bit.... if you see my logic.

60 notes saved.

#tightasfook

Click to expand...

Yup, understood...

Hope the bit from the old exhaust you want to weld in is long enough.