monty1
New Member
- Posts
- 143
- Location
- eston middlesbrough
fob stopped working so put new batterys in x 2,led light not working and im using the eka code to get in and start it do i need a new fob i only got 1 with the car
tia tony
tia tony
key fob problem
- Thread starter monty1
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tommo138
New Member
- Posts
- 541
- Location
- braintree, essex
sounds like you've put the batteries in the wrong way, check and make sure the connections are clean.
Datatek
Well-Known Member
- Posts
- 44,042
- Location
- Near Poitiers SW France
Sure to be batteries in wrong as tommo138 said, or the little metal contacts are bent. Either way you have to get the little LED has to work.
monty1
New Member
- Posts
- 143
- Location
- eston middlesbrough
batterys are in the right way contacts are clean and ok,new fob required i think
Datatek
Well-Known Member
- Posts
- 44,042
- Location
- Near Poitiers SW France
No good doing any of that if the LED doesn't light on the FOB. The FOB is inactive and it is almost always a bad connection after the batteries have been replaced.
- Posts
- 58,170
- Location
- Preston Lancs.
Put battery carrier in place lined up with mark. But do not turn to engage. Press lock button and turn battery holder into position whilst holding lock button down. LED should not work.
monty1
New Member
- Posts
- 143
- Location
- eston middlesbrough
just tried that,didnt work
nathan5346
Well-Known Member
- Posts
- 11,939
- Location
- oldbury
if the led worked b4 bat change it must be bad contact or uv fecked it, get the led working put the key in lock press and hold lock on the fob and lock with the key that'll resync the fob.
monty1
New Member
- Posts
- 143
- Location
- eston middlesbrough
i give the contacts a clean and a gentle scrape with a screw driver and its now working,used eka and synced the key and all is good
thanks for the promt replys and help
thanks for the promt replys and help
