Injector Codes . Hawkeye

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
BigDons

BigDons

Member
Posts
63
Location
Dunbar, Scotland
Hi Guys,
I have an over fueling prob at the moment. I looked at the injector codes on the hawkeye and got the following.

NMNBC
LBGHA
NDBGA
NCNCA
NCBLA

My question is, .. should they all start " N " ? As I found it odd the LBGH coide there ?

Cheers,

Dons x
 
There just tolerance referance numbers.

Mine start with 3 "N",s, 1 "L", and a "B" !.

Have you got black smoke on accelaration ?.

Del.
 
May not be overfuelling, but lack of air flow !.

Things to check are, air filter, turbo hoses, ( delamination causing restriction ), air flow meter, ( unplug it, take the car for a blast and see if its any different ) and the EGR valve.

Have you got any faults logged ?.

Del.
 
I've just renewed the
MAF sensor,
Wastegae Modulator,
Intercooler,
All Turbo hoses to silicone,
Fuel Regulator,
EGR Blanked,
ECU cleaned,
Head Gasket.

No fault codes apart from EGR blanked.


Now at my wits end.
 
BigDons said:
Tiny amount at idle. But when you boot it, or put it under load eg, pulling unladen trailer it blows the black stuff.
Click to expand...

Has it been re-mapped ?

How well does it go ?.

Whats it like on fuel ?.

What are your air flow and pressure figures at full throttle ?.

Del.
 
Has not been remapped.

Goes reasonable, but not as good as before new gasket.

Air flow and pressures were within normal range acording to another thread., I'll have to look for me bit of paper again.. hold on.

Was using fuel a bit under load, but seems ok at the moment.
 
Could be your turbo, as, when I floor mine I get the figures I quoted above.

Do a bit of googling and I,m sure you,ll find that your figures are too low.

( to clarify. my figures are when foot is flat to the floor between 2000 and 3000 rpm ).

Del.
 
Hi Del,

Cheers M8. Very much apreciated. Getting hold of a mates one tomorrow just to see if it makes a difference before splashing out.

Will update as soon as I know.

Dons x
 
You must log in or register to reply here.

Similar threads

C
More Amigo Fun
2
Replies
20
Views
987
Charlie Chester
C
Chazb5046
Disco 2 Injector seals - fuel line removal?
Replies
1
Views
436
sierrafery
sierrafery
Gothicsera
Discovery 2 TD5 Lack of Power
2 3
Replies
46
Views
2K
Gothicsera
Gothicsera
T
TD5 crank no start after overheating
Replies
1
Views
297
tom1979
tom1979
M
Crankcase breather assembly question
Replies
6
Views
324
MGT
M
Back
Top