Indicators

My indicators have always been a bit temperamental, blowing fuses and flasher units. But this time they are kapoot!!!!
I have checked all the fuses and changed the flasher unit replaced the hazard light switch and still nothing.
Any sensible ideas of what to try would be appreciated.

switch faulty, or a wire chafed through.

check yer alarm wirin anurl if yer got one specially if its connected to ya indicators

oil dripper said:

check yer alarm wirin anurl if yer got one specially if its connected to ya indicators

Click to expand...

That was what was makin your bugger about in the end were it drippy?

boydy1989 said:

That was what was makin your bugger about in the end were it drippy?

Click to expand...

yea bastid fing,was the wire that meks ya indicators flash wen ya arm ya alarm was chaffin away unda me air filter .
i got them workin ok.
but it,s dun damage elsewhere,not critically important stuff just miffed at it,but i aint rippin me dash out ta find it

Could be your hazard switch, everything indicator related goes through this and if it goes wrong it can stop everything.

When I got my 90 it had a dodgy switch, I had indicators OK but the hazards needed the switch to be held midway. I took it apart and the contacts had welded together and melted through etc.

I had a used one in the LR so I fitted that and it didn't work properly although it didn't have any fried looking contacts.

I bought a new one off ebay and then discovered it was not setup properly, there is a bar which is supposed to be over a contact and that gets pushed down onto it to kill the indicators. This was under the contact so I pulled it out and fixed it and it then worked fine.